![]() Only these speeds are allowed with this setting.Īuto-1000: Uses 1000 Mbps and negotiates with the port at the other end of the link for other port operation features. (Cat 5 cabling is required for 100 Mbps links.).Īuto-100: Uses 100 Mbps and negotiates with the port at the other end of the link for other port operation features.Īuto-10-100: Allows the port to establish a link with the port at the other end at either 10 Mbps or 100 Mbps, using the highest mutual speed and duplex mode available. HP recommends auto-10 for links between 10/100 auto-sensing ports connected with Cat 3 cabling. Also negotiates flow control (enabled or disabled). ![]() MDIX: Sets the port to connect with a PC using a straight-through cable (manual mode-applies only to copper port switches using twisted-pair copper Ethernet cables)Īuto-10: Allows the port to negotiate between half-duplex (HDx) and full-duplex (FDx) while keeping speed at 10 Mbps. MDI: Sets the port to connect with a PC using a crossover cable (manual mode-applies only to copper port switches using twisted-pair copper Ethernet cables) Status and Counters in the menu interface. ![]() To see what the switch negotiates for the auto setting, use theCLI show interfaces brief command or the 3. ![]() Auto-MDIX (default): Senses speed and negotiates with the port at the other end of the link for port operation (MDI-X or MDI). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |